201 Exam Dumps - PDF Questions and Testing Engine
201 Dumps - The Sure Way To Pass Exam
Who should take the F5-201: TMOS Administration Exam
People who are interested in getting a F5 Professional Certification which validates your expertise in manipulating the entire application stack - from traditional network knowledge all the way to advanced application-layer understanding, with the ability to integrate those two worlds. Candidates should have a basic understanding of network fundamentals, protocols, and common traffic management concepts. The student should also understand the basic concepts of F5 technology as applied to network fundamentals, protocols, and traffic management.
Candidates should have the following knowledge/capabilities:
- Articulate the advantages of a full application proxy.
- Identify and define the components of TMOS (F5 Traffic Management Operating System).
- Explain the seven layers of the Open Systems Interconnection (OSI) model.
- Describe valid uses/methods of HTTP.
Average Salary of F5-201: TMOS Administration Exam Certified Professionals
The average salary of a AI-900: Microsoft Azure AI Fundamentals Exam Outlook and Modules Exam Certified Expert in:
- United State - 108,682 USD
- England - 61,267 POUND
- India - 9,71,117 INR
- Europe - 97,440 EURO
NEW QUESTION 33
The BIG-IP Administrator generates QKView using tmsh command "qkview -SO". In which directory does the BIG-IP appliance save the QKView?
- A. /shared/qkview
- B. /etc/tmp
- C. /var /tmp/qkview
- D. /var/tmp
Answer: D
NEW QUESTION 34
A BIG-IP Administrator is checking the BIG-IP device for known vulnerabilities. What should the 8IG-IP Administrator upload to BIG-IP iHealth for further analysis?
- A. tcpdump
- B. UCS
- C. EUD
- D. QKView
Answer: D
NEW QUESTION 35
Which method is recommended for creating a new user from the CLI?
- A. Run tmsh create auth user username prompt for password' from bash
- B. Run useradd username' then 'passwd username' from bash tmsh
- C. Run f5adduser username' then 'f5passwd username' from bash or tmsh
- D. edit bigip.conf to add the new user and the user's clear-text password
Answer: A
NEW QUESTION 36
Refer to the exhibit.
How long will the persistence record remain in the table?
- A. 180 seconds after the initial table entry
- B. 300 seconds after the initial table entry
- C. 300 seconds after the last packet
- D. 180 seconds after the last packet
Answer: C
NEW QUESTION 37
Active connections to pool members are unevenly distributed. The load balancing method is Least Connections (member) Priority Group Activation is disabled. What is a potential cause of the event distribution?
- A. Persistence profile is applied
- B. SSL Profile Server is applied
- C. Priority Group Activation is disabled
- D. incorrect load balancing method
Answer: A
NEW QUESTION 38
A user wants to use the iHealth Upgrade Advisor to determine any issues with upgrading TMOS from 13.0 to
13.1.
Where can the user generate the QKView to upload to iHealth?
- A. System > Software Management
- B. System > Archives
- C. System > Support
- D. System > Configuration
Answer: C
NEW QUESTION 39
A BIG-IP Administrator is creating a new Trunk on the BIG-IP device. What objects should be added to the new Trunk being created?
- A. Interfaces
- B. Network routes
- C. VLANS
- D. IP addresses
Answer: A
Explanation:
trunk is a portchannel, you need to add a physical interface.
NEW QUESTION 40
A BIG-IP Administrator is receiving intermittent reports from users that SSL connections to the BIG-IP device are failing. Upon checking the log files, the BIG-IP Administrator notices the following error message:
ere tmm<instance>[<pid>]: 01260008:3: SSL transaction (TPS) rate limit reached After reviewing statistics, the BIG-IP Administrator notices there are a maximum of 1200 client-side SSL TPS and a maximum of 800 server-side SSL TPS.
What is the minimum SSL license limit capacity the BIG-IP Administrator should upgrade to handle this peak?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 41
A BIG-IP Administrator uses a device group to share the workload and needs to perform service on a BIG-IP device currently active for a traffic group. The administrator needs to enable the traffic group to run on another BIG-IP device in the device group. What should the administrator do to meet the requirement?
- A. Select Traffic Group and then select Failover
- B. Select Traffic Group and then select Force to Standby
- C. Create a new Traffic Group and then fail to Standby Unit
- D. Select Traffic Group on Primary Unit and then select Demote
Answer: B
NEW QUESTION 42
You have created a custom profile named TEST2. The parent profile of TEST2 is named TEST1. If additional changes are made to TEST1, what is the effect on TEST2.
- A. Changes to TEST1 cannot affect TEST2 once TEST2 is saved.
- B. Some of the changes to TEST1 may propagate to TEST2.
- C. All changes to TEST1 are propagated to TEST2.
- D. When TEST1 is changed, the administrator is prompted and can choose whether to propagate changes to TEST2.
Answer: B
NEW QUESTION 43
A BIG-IP Administrator must determine if a Virtual Address is configured to fail over to the standby member of a device group in which area of the Configuration Utility can this be confirmed?
- A. Device Management > Overview
- B. Device Management > Traffic Groups
- C. Device Management > Devices
- D. Local Traffic > Virtual Servers
Answer: D
NEW QUESTION 44
A virtual server at 10.10.1.100:80 has the
rule listed below applied. when HTTP_REQUEST { if {[HTTP::uri] ends_with "htm" } { pool pool1 } elseif {[HTTP::uri] ends_with "xt" } { pool pool2 } If a user connects to http://10.10.1.100/foo.txt which pool will receive the request.
- A. pool1
- B. None. The request will be dropped.
- C. pool2
- D. Unknown. The pool cannot be determined from the information provided.
Answer: C
NEW QUESTION 45
You need to terminate client SSL traffic at the BIGElIP and also to persist client traffic to the same pool member based on a BIGElIP supplied cookie. Which four are profiles that would normally be included in the virtual server's definition. (Choose four.)
- A. HTTP
- B. ServerSSL
- C. TCP
- D. CookieElBased Persistence
- E. HTTPS
- F. ClientSSL
Answer: A,C,D,F
NEW QUESTION 46
A BIG-IP Administrator must configure the BIG-IP device to send system log messages to a remote syslog server In addition, the log messages need to be sent over TCP for guaranteed delivery. What should the BIG-IP Administrator configure?
- A. Request Logging Profile
- B. Remote Logging
- C. syslog-ng
- D. HSL Logging
Answer: B
NEW QUESTION 47
A BIG-IP device sends out the following SNMP trap:
big-ipo.f5.com - bigipExternalLinkChange Link: 1.0 is DOWN
Where in the BIG-IP Configuration utility should the BIG-IP Administrator verify the current status of Link
1.0?
- A. Network > Interfaces > Interface List
1.0 is a physical interface, you can see the interface status from the physical interface in the network. - B. Statistics > Performance > System
- C. System > Platform
- D. Network > Trunks > Trunk List
Answer: A
NEW QUESTION 48
A BIG-IP Administrator is informed that traffic on Interface 1.1 is expected to increase over the maximum bandwidth capacity on the link. There is a single VLAN on the Interface. What should the 8IG-IP Administrator do to increase the total available bandwidth?
- A. Create a trunk object with two Interfaces
- B. Set the media speed of Interface 1.1 manually
- C. Increase the MTU on the VLAN using Interface 1.1
- D. Assign two Interfaces to the VLAN
Answer: A
NEW QUESTION 49
A BIG-IP Administrator sees the following error message in /var/log/ltm diskmonitor: *******; Disk partition shared has less than 30$ free Which section of the Configuration Utility should the BIG-IP Administrator access to investigate this error message?
- A. Statistics > Module Statistics > System
- B. System > Disk Management
- C. Statistics > Analytics
- D. System > File Management
Answer: B
NEW QUESTION 50
The owner of a web application asks the 8IG-IP Administrator to change the port that the BIG-IP device sends traffic to. This change must be made for each member in the server pool named app_pool for their Virtual Server named app_vs. In which area of the BIG-IP Configuration Utility should the BIG-P Administrator make this change?
- A. Network > Interfaces
- B. Local Traffic > Pools
- C. Local Traffic > Virtual Servers
- D. Local Traffic > Nodes
Answer: B
NEW QUESTION 51
A site has assigned the ICMP
monitor to all nodes and a custom monitor, based on the HTTP template,
to a pool of web
servers. The HTTPElbased monitor
is working in all cases. The ICMP monitor is failing for 2 of the pool member 5 nodes. All other settings are default. What is the status of the monitor is working in all cases. The ICMP monitor is failing for 2 of the pool member. 5 nodes. All other settings are default. What is the status of the pool members.
- A. The pool members whose nodes are failing the ICMPElbased monitor will be marked unavailable.
- B. All pool members are up since the HTTPElbased monitor is successful.
- C. All pool members are down since the ICMPElbased monitor is failing in some cases.
- D. The pool members whose nodes are failing the ICMPElbased monitor will be marked disabled.
Answer: A
NEW QUESTION 52
Refer to the exhibit.
A BIG-IP Administrator creates a new Virtual Server. The end user is unable to access the page. During troubleshooting, the administrator learns that the connection between the BIG-IP system and server is NOT set up correctly.
What should the administrator do to solve this issue?
- A. Set Address Translation to SNAT and configure a specific translation address
- B. Set Address Translation to SNAT and have self-IP configured in the same subnet of servers
- C. Set Address Translation to Auto Map, configure a SNAT pool, and have pool members in the same subnet of the servers
- D. Disable Address Translation
Answer: A
Explanation:
Explanation
The status of the pool can be seen that the members are all up, indicating that the network from F5 to the server is no problem, so there is no need to configure selfip on the same subnet. The monitor is normal but the access is not normal, you have to consider the problem of snat, you can configure automap or configure snat and specify snat ip.
NEW QUESTION 53
A BIGJP Administrator needs to load a UCS file but must exclude the license file. How should the administrator perform this task?
- A. From the CLI with command U tmsh load /$ys ucs <ucs filename> no-license
- B. From the GUI, select the UCS file and click restore
- C. From the GUI, select the UCS file, unchcck the license box, and click restore
- D. From the CLI with command(tmos) tmsh load /sys ucs <ucs filename> no-license
Answer: A
NEW QUESTION 54
......
Pass F5 201 Exam Quickly With UpdateDumps: https://www.updatedumps.com/F5/201-updated-exam-dumps.html
201 Exam Questions (Updated 2021) 100% Real Question Answers: https://drive.google.com/open?id=1MHIp7evIryNp5FN1fjK7wb25tEeLcfd8